Blog

Where is the diagnostic port on a 2000 Toyota 4Runner?

Where is the diagnostic port on a 2000 Toyota 4Runner?

On the 2000 4Runner, the data link connector is located just under the dashboard in the driver side area, to the right of the steering column.

Where is the OBD port on a 1999 Toyota 4Runner?

It is under the dash, driver’s side, to the right of the steering column. The port is required to be under the dash, within 3′ of the driver’s seat, and you must be able to locate it without any tools.

How do you reset the check engine light on a 2000 Toyota 4runner?

To reset the check engine light on the toyota, unplug the battery. Hold the car for for around 30 seconds to make sure that the electricity is drained. Wait about 15 minutes for the error codes to be gone and the engine lights turn off.

Where is the obd2 port on a 2002 4runner?

One in the engine bay one the drivers side, attached to an intake plenum (has a cover on it) and the other inside, down low behind the center console in an opening next to the gas pedal.

Where is my car diagnostic port?

The OBD-II port is usually located under the dashboard, beneath the steering wheel column (1 – 3 in the diagram below). If not located beneath the steering column, look for the port in the areas indicated by numbers 4 – 9. For additional info, check out these Hum FAQs.

Where is the OBD port on a 95 Toyota 4runner?

Look under the hood for a small plastic box labeled “Diagnostic.” If you have the box inside are electrical terminals.

Where is the OBD port on a 2011 Toyota Tacoma?

OBD connector location for Toyota Tacoma (2005 – 2015)

  1. Connector is under the steering wheel (left side)
  2. Connector is located above the parking brake pedal.
  3. OBD plug.

How do you turn off the check engine light on a toyota?

1. Using a Scan Tool

  1. Connect the scan tool to the onboard diagnostic connector. This is found under the steering column.
  2. Press the READ button on the scan tool, and look for any error codes.
  3. Press the ERASE button on the tool to remove the error code. The check engine light will then turn off.

How do you reset the check engine light on a 1999 toyota 4runner?

Share this post